Operator`s manual
Table Of Contents
- Operator's Manual A3-2/A3/A4/A6
- Copyright
- Table of Contents
- Trademarks
- A General Guide to the Documentation
- 1. Product Description
- 2. General Safety Instructions
- 3. Unpacking
- 4. Printer Component Location
- 5. Connecting the Printer
- 6. Control Panel
- 7. Media Loading
- 8. Printer Configuration
- 9. Test Options
- 10. Memory Cards
- 11. External Keyboard
- Appendix A - Operation in Peel-off Mode
- Appendix B - Pin Assignment of the Interface Connectors
- Appendix C - Error Messages / Problem Solution
- Appendix D - Maintenance / Cleaning
- Appendix E - Replacing Assembly Units
- Appendix F - Firmware Updates
- Index
- EU - Conformity Declaration
31cab Produkttechnik GmbH & Co KG
A3-2 / A3 / A4 / A6
1
2
5. Connecting the Printer
5. Connecting the Printer
CAUTION !
Make sure the printer is located where the unit or the operator cannot
come in contact with water. Otherwise it could cause damage to the
printer.
Connection to Power Supply
The printer is equipped with a wide range power unit (100-240V~), so it is
possible to use the printer both with a voltage of 230V~/50 Hz and with a
voltage of 115V~/60 Hz without making changes to the printer.
CAUTION !
Make sure the power switch (1) is in position "
O
" (OFF) before
connecting the printer to a power supply !
Fig. 5a Power supply
Insert the power cable supplied in the accessories carton into the power supply
connector (2) and contact the cable to a grounded outlet.