Operator`s manual
Table Of Contents
- Operator's Manual A3-2/A3/A4/A6
- Copyright
- Table of Contents
- Trademarks
- A General Guide to the Documentation
- 1. Product Description
- 2. General Safety Instructions
- 3. Unpacking
- 4. Printer Component Location
- 5. Connecting the Printer
- 6. Control Panel
- 7. Media Loading
- 8. Printer Configuration
- 9. Test Options
- 10. Memory Cards
- 11. External Keyboard
- Appendix A - Operation in Peel-off Mode
- Appendix B - Pin Assignment of the Interface Connectors
- Appendix C - Error Messages / Problem Solution
- Appendix D - Maintenance / Cleaning
- Appendix E - Replacing Assembly Units
- Appendix F - Firmware Updates
- Index
- EU - Conformity Declaration
17cab Produkttechnik GmbH & Co KG
A3-2 / A3 / A4 / A6 1. Product Description
External Keyboard
The keyboard connector allows you to connect your printer to an USB
keyboard. This will allow you to input variable data to a format stored on a
memory card.
Interface Extensions
The printer is equipped with a slot to connect an additional interface.
It is possible to install a RS-422/485 interface, an USB interface or an
ethernet interface allowing the printer to be connected to several different
types of interfaces and networks.
Applicator
The applicator A 1000 represents, in combination with the P-versions of A3-2,
A3 and A4, the inexpensive solution both for the semi-automatic labeling and
for the integration into automated production lines.
RFID Read-Write Unit
The A3 and A4 could be supplied with a factory installed RFID Read-Write Unit
13.56 MHz with Ethernet for the marking of smart labels.