Technical data

cab | 8
Accessories for basic devices.
Cutter
The cutter is used to cut
paper, pressure sensitive
labels, cardboard, textiles,
synthetics or heat shrink
tubes.
Rewind guide plate for internal rewinding
The dispensing printer takes care of internal rewinding. The peel-off
plate is replaced by the rewind guide plate (for devices A2
+
and A4
+
).
ER1 / 2 / 3 external rewinder for direct printer connection
The rewinder is screwed directly onto the printer. Labels can be
wound either inside or outside. Electronic control of the swing arm
ensures smooth and tight winding.
ER4 / 6 / 8 external rewinder with built-in power supply
The rewinder can be attached to almost any third-party printer.
All other technical data is the same as for the rewinder ER1 / 2 / 3.
EU4 / 6 / 8 external unwinder
It enables smooth label feed for heavy rolls. The unwinder works both
with inside and outside wound labels.
Tester for linear barcodes
The built-in scanner tests horizontally printed barcodes directly after
printing. If the barcode cannot be read, the printing process can be
stopped at once so the faulty labels can be removed. It is primarily
intended for use with the ER4 – ER8 external rewinder or in dispens-
ing mode.
Hand or foot switch for printing on demand (see page 9).
External rewinder External unwinder
ER1 / 210 ER4 / 210 ER4 / 300 EU4 / 300
Material width up to mm 120 120 120 120
Roll Ø max. mm 205 205 300 300
Core Ø mm 40 / 76 40 / 76 40 / 76 40 / 76
Operating voltage From label printer 100 – 240 V~ 50 / 60 Hz –
Label winding Outside or inside
Cutter CU4
Material width up to mm 120
Weight of material
gr / m
2
/ cardboard
60 – 500
Material thickness mm 0.05 – 0.8
Cutting length mm > 5
Gap height up to mm 2.5
Cuts / min 120
Stop print job if
Final position
not reached