Technical data

cab | 11
Accessories for applicators.
Tamp pad
The product remains fixed in place during application. The vacuum
holes of the universal tamp pads are covered by a foil that is pierced
according to the label size. The tamp pads are adjusted to the
external dimensions of the labels.
Blow pad
The label can be blown on for pressure-sensitive products. The labels
can be applied to either a fixed or moving product. The product to be
printed is positioned approximately 10 mm below the blow pad.
Roll-on pad
The label is moved under the roll during application. The pad moves
onto the product and the label is rolled on during transportation.
Digital I/O interface at the applicator
The master (e.g. PLC) starts or stops the labeling
process. Status and error messages are issued at
the same time.
Input / output
› Start
› Stop
› Print first label
› Printer not ready
› No print job
› Combined alarm
› Basic position reached
› Labeling position reached
› Labeling error
Printing and dispensing on demand
A hand or foot switch or a product sensor can be attached at the
applicator‘s digital I/O interface to start print jobs.
Hand switch
Starts printing and dispensing.
Foot switch
Starts printing and dispensing.
Product sensor
For automatic product detection on the
conveyor belt.
Sub D plug
To connect external control signals
at the applicator. Sub D plug 15-pin with
screw clamps.
External operation panel
If the external panel is no longer accessible,
e.g. after installation within a facility, an
external panel can be installed. There are
additional slots for a CF Type I memory card
and a USB master interface.