Service manual

57
A 3
5.6 Justage Kopfschalter
Lebensgefahr!
Trennen Sie den Drucker vom Netz-
anschluss sonst besteht Lebensgefahr
durch spannungsführende Leiter im
Innern des geöffneten Druckers!
Der Schalter verhindert einen Druckbetrieb bei geöffnetem
Druckkopf.
Eine Justage kann dann notwendig sein, wenn trotz verrie-
geltem Druckkopf die Fehlermeldung "Kopf abgeklappt" im
Display erscheint.
Zur Justage des Kopfschalters gehen Sie wie folgt vor:
1. Trennen Sie den Drucker vom Netzanschluss!
2. Demontieren Sie die Rückwand.
3. Verriegeln Sie den Druckkopf.
4. Lösen Sie die Schraube (2) des Zwischenträgers für
den Kopfschalter (1) leicht.
5. Bringen Sie Kopfschalter-Gehäuse (1) und Schaltbügel
(3) in eine parallele Stellung (siehe Bild 43, vergrößer-
ter Ausschnitt des Schaltergehäuses und des Schalt-
bügels) und schrauben Sie den Zwischenträger mit
Kopfschalter in dieser Stellung wieder fest. Die
Kopfschalterjustage ist damit abgeschlossen. Sollte die
Displaymeldung "Kopf abgeklappt" noch erscheinen ist
der Kopfschalter zu erneuern.
6. Montieren Sie die Rückwand.
Bild 43 1 Kopfschalter
2 Schraube Zwischenträger
3 Schaltbügel
Fig. 43 1 Head switch
2 Intermediate holder screw
3 Switch lever
5.6 Adjusting the head switch
Danger to life and limb
Disconnect the printer from the mains
connection, otherwise there is a risk to
life and limb from the live wires inside the
open printer.
This switch prevents printing operations while the printhead
is open.
An adjustment may become necessary if the error message
"Head open" appears in the display, although the printhead
is locked.
The head switch is adjusted as follows:
1. Disconnect the printer from the mains connection.
2. Remove the rear cover of the printer.
3. Lock the printhead.
4. Slightly loosen the screw (2) on the intermediate holder
for the head switch (1).
5. Bring the head switch casing (1) and the switch lever
(3) into a parallel position (see figure 43, enlarged
section of the switch casing and switch lever), and
screw the intermediate holder with the head switch tight
in this position. The head switch adjustment has now
been completed. Should the "Head open" message still
appear on the display then the head switch must be
replaced.
6. Refit the rear cover of the printer.