Service manual

53
A 3
5.5 Justage der Wickelmomente
Lebensgefahr!
Trennen Sie den Drucker vom Netz-
anschluss sonst besteht Lebensgefahr
durch spannungsführende Leiter im
Innern des geöffneten Druckers!
Der Transferfolienaufwickler sowie der interne Aufwickler
sind mit Rutschkupplungen in den Hauptantrieb
eingekoppelt.
Mit einer weiteren Rutschkupplung wird der Transferfolien-
abwickler im Druckbetrieb gebremst.
Die korrekte Einstellung der Momente dieser Kupplungen
ist notwendig für:
a) eine exakte Mitnahme der Transferfolie beim
Etikettentransport,
b) die Vermeidung von Falten im Transferfolienlauf,
c) einen ausreichend straffen Spendezug des Trägerbandes
und damit für ein leichtes Ablösen der Etiketten im
Spendemodus.
Messung am Transferfolienauf- und Abwickler:
Die Messung der Momente erfolgt über die Bestimmung der
Zugkräfte an einem auf den jeweiligen Wickler aufgesteck-
ten Prüfkörper (Artikel-Nr. 553 4199).
Der physikalische Zusammenhang zwischen Moment und
Zugkraft lautet:
F = M / r F = Zugkraft
M = Wickelmoment
r = Radius des Prüfkörpers (30 mm)
Sollwerte :
Transferfolienaufwickler
M
Auf
= 19 - 25,5 Ncm F
Auf
= 6,3 - 8,5 N
Transferfolienabwickler
M
Ab
= 4 - 4,5 Ncm F
Ab
= 1,3 - 1,5 N
5.5 Adjusting the hub torques
Danger to life and limb
Disconnect the printer from the mains
connection, otherwise there is a risk to
life and limb from the live wires inside the
open printer.
The transfer ribbon rewinder and the internal rewinder are
coupled to the main drive by a slipping clutch.
The ribbon supply hub is braked during printing by another
slipping clutch.
The torques of these clutches must be set correctly in order
to:
a) ensure the exact transport of the transfer ribbon during
label transport;
b) prevent wrinkles forming in the transfer ribbon supply;
c) ensure adequate tension in the silicon liner so that
the labels peel off easily in dispensing mode.
Measuring the torques at the rewind and supply hubs:
The torques are measured by determining the traction using
a test collar (item no. 553 4199) at the rewind hub or the
supply hub.
The physical relation between torque and traction is as
follows:
F = M / r F = traction
M = rewind torque
r = radius of test collar (1.2 in/30 mm)
Set values:
Transfer ribbon rewind hub
M
rewind
= 19 - 25.5 Ncm F
rewind
= 6.3 - 8.5 N
Transfer ribbon supply hub
M
supply
= 4 - 4.5 Ncm F
supply
= 1.3 - 1.5 N