Technical data

Internal Rewinding of Labels
Label rolls up to 145 mm/5.7" diameter
can be rewinded with the internal rewinder after
printing.
Printing and Tearing off Labels
After printing, labels and continuous material can
be torn off using the tear-Off plate.
Cutting Labels
The cutter is used to cut labels, cardboard, textil
or plastic foils or even heat-shrinkable tubes one
label after the other, after a certain number of
labels or at the end of the print job. We recom-
mend that you test very rigid or thin material in
advance.
The cutter tray is useful for collecting cut labels
that are a width of 30 - 116 mm/1.18 - 4.56" and
a height of 12 - 100 mm/0.47 - 3.93". The maxi-
mum stacking height is 36 mm/1.41".
External Rewinding of Labels
Label rolls up to 210 mm/8" diameter
The rewinder is fixed direct to the transfer printer.
The winding can be inside or outside by choice.
Dispensing Labels
On the present plate the label is peeled off from
the liner. The imprint and dispense quality is very
high due to the additional driven rewind assist
roller and the locking system.
There are three present modules to handle the
present function:
The right Accessories for every Application
6
P-version with present function Basic device
Basic device
Basic deviceR-Version with internal rewinder
PS7: Pause adapter for the A-Series
Via the accessories interface the print
job can be interupted and the status
of the printer can be requested in all
A-Series printers.
PS 8: Present sensor for the A/M-Series
manual operation
The present sensor indicates the label
in the present position and stopps the
printing job. After removing of the
label, the next one is printed.
PS 6: Present sensor for the A-Series
manual and automatic operation
The indication of the label in the
present position is also done via the
present sensor. With an additional
accessories interface status reports like "label in
present position" or "printer offline" can be send
to an external application.
PS 5: Peel-off adapter for the A-Series
automatic operation
The peel-off adapter runs without an
optical sensor. The transfer of the
label by an applicator or roboter is
generated by an external signal. All other functions
are identical to PS6.
Present trigger for PS5 and PS6
To start the print and
the presenting of the
next label a connection
of a present trigger or
foot switch is possible.