Spec Sheet

1
2
3
4
5
DR4-25
DR4-50
3
Details
1
Roll holder
The label roll is inserted and
automatically centered when closing.
2
Ribbon holder
The stop can be adjusted
according to the ribbon width.
3
Print head 203 / 300 dpi
In case of cleaning or wear, the print head
can be replaced easily by hand without tools.
4
Label sensor - gap or reective
The sensor position can be adjusted
via a spindle using the red rotary knob.
The chosen position is indicated by a LED.
5
Print roller DR4
In case of cleaning or wear, the print roller
can be replaced without tools.
6
Material guide
Using the rotary knob, the guides
can be adjusted to the material width
7
Tear-o plate
made of thin sheet steel;
jagged, so labels are cleanly separated
Interfaces on the back of the device
1
for SD memory card
2
2 x USB host to connect a Service Key,
USB memory stick, keyboard, barcode scanner,
USB Bluetooth adapter, USB WLAN stick
3
USB 2.0 Hi-speed Device to connect a PC
4
Ethernet 10/100 BASE-T
5
RS232C 1,200 to 230,400 baud/8 bit
Operation panel
1
LED signal: Power ON
2
Status bar: Data reception, Record data stream, Ribbon pre-warning,
SD memory card / USB memory stick, Bluetooth,
WLAN, Ethernet, USB slave, Time
3
Printer status: Ready, Pause, Number of printed labels per print job,
Label in peel-o position, Awaiting external start signal
4
Buttons for cutter / perforation cutter: direct cutting
tear-o mode: print the next label
5
USB slot for the Service Key or a memory stick,
to load data in the IFFS storage
6
Operation:
Intuitive and easy operation with self-explanatory symbols
to congure the device setups
To achieve accurate imprint with slim materials
and ribbons, slim print rollers are needed.
These prevent from print roller wear, print head
contamination and errors during material feed.
Jump to menu
Stop and delete all print jobs
Label feed
Interrupt and continue print job
Reprint last label
1
2
3
4
5
7
6
3
4
6
2
5
1