User manual

Notes:
The DAS IP address will pop up in the right hand bottom corner of the TV on DAS boot up (the DAS
must be networked first for this to happen and a TV connected to the DAS HDMI port).
The DAS IP address can also be found by using the App Fing on your smart phone / tablet.
Alternatively if CEC is enabled on your TV, you can use the TV remote to scroll to System
System info where the IP address will be displayed.
Keep the login and password blank, they are not needed.
The DAS needs to be running before you configure Yatse.
For more info please see: http://yatse.leetzone.org/redmine/projects/androidwidget/wiki/Setup
Using Yatse Remote App
The Yatse remote is very intuitive. All the functions can be accessed from the menu screen (top right corner):
1. Open / Run the Yatse App.
2. Select the menu screen (three small lines in the top right corner or swipe from left to right).
3. Select remote to bring up a remote key pad. This will allow you to navigate all the DAS functions
viewable on a HDMI TV.
4. Select Music to bring up your whole music library (a library must to built first, see section Building
an XBMC music library).
5. The Yatse App will need synchronising with the DAS:
Press and hold the Music icon to sync with the DAS.
You will see a message starting database sync (if you have a large music library this may take
a while.
When finished, your music library will be stored along with all thumbnails and cover art.
6. Select Music, you can then scroll though your music library and select and play any tracks you wish.
Page 16