User`s manual

BX-PIB0x Embedded Box System
18
2.3 Installing Internal Components
CAUTION:
Before removing the cover, make sure the system has been
shut down and the power cord has been unplugged.
2.3.1 Removing the Top Cover
1. Remove the three screws from the front panel and the three screws
from the rear panel.
2. Remove the four Allen screws (3 mm) from the top of the cover.
3. Lift the cover off of the chassis.
4. To replace the cover, reverse the steps above.
CAUTION:
Check that the thermal pads have not been damaged. Improper
thermal contact between the heat spreader and heat sink may
result in overheating and damage to the system.