Service manual

______________

ACCESSORIES

ELECTRONIC CROSSOVER:

The Electronic Crossover accessory is an electronic interface between two labeling heads positioned in

series that will monitor labeling head fault conditions and switch to a secondary applicator to prevent

interruption of production flow. Includes control with all interface cabling.

IMPRINTER:

The Imprinter accessory is a Hot Stamp Imprinter device mounted on special bracketry attached to the

labeling head.

LOOSE LOOP:

The Loose Loop accessory is designed to integrate a labeling head with a Thermal / Thermal Transfer

printer in “Loose Loop” fashion. This option includes electrical modifications to the printer, sensor array

to monitor loop condition, and all mounting hardware (including yard arm) to support the labeling head

and printer from a vertical upright.

LOW LABEL DETECTION:

The Low Label Detection accessory is a sensor that generates a signal when the unwind is low on labels.

The applicator will display an alarm screen and activate the strobe light (if purchased) to inform the

operator that the unwind is about to run out of labels.

TAMP SWITCH:

The Tamp Switch accessory uses two sensors to control the tamp slide assembly when labeling products

with differing heights. When the tamp home switch is activated, the applicator dispenses a label onto the

tamp pad. The tamp extend switch senses the product, a label is applied, and the tamp returns to the home

position.

WEB BREAK DETECTION:

The Web Break Detection accessory is a sensor that generates a signal when there is a break in the web.

The applicator will display an alarm screen and flash the strobe light (if purchased) to inform the operator

that the label web is broken.