Service manual

_____________________

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

LABEL PLACEMENT ON GRID OR AIR BLOW YOU MAY HAVE TO MASK OFF

LABEL PAD NOT CONSISTENT IMPROPER VACUUM THE HOLES NOT USED BY THE LABEL

ON THE INSIDE OF THE VACUUM BOX

YOU CAN ADD MORE VACUUM

BY TURNING THE VAC SWITCH TO HIGH

TAMP ADJUST AIR PRESSURE

IMPROPER VACUUM

BOTH REPLACE LABEL ROLL

ADHESIVE STRINGS ON LABEL

AND LINER

BOTH REFER TO PEEL EDGE ALIGNMENT

PEEL EDGE OUT OF ADJUSTMENT IN THE LABELER SET UP SECTION

BOTH EXAMINE AND CORRECT

INCORRECT EXTENDED AIR ASSIST TIME

BOTH REFER TO AIR ASSIST SET UP

AIR ASSIST TUBE NOT IN THE LABELER SET UP

ALIGNED PROPERLY SECTION

LABEL FAILS TO LEAVE THE LABEL AIR BLOW SWITCH TO LOW ON VAC SWITCH

GRID OR LABEL PAD TOO MUCH VACUUM

REMOVE MASKING

BOTH AIR BLAST TIME TOO SMALL

NO AIR BLAST

IF BAD VALVE; REPLACE

AIR BLOW INSPECT AND CORRECT

INCORRECT AIR JET PATTERN