Service manual

_____________________

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

LABEL LINER NOT WINDING UP REWIND SLIP CLUTCH NEEDS SEE SLIP CLUTCH ADJUSTMENT

TENSIONING OR REPLACED IN THE MAINTENANCE SECTION

ONE-WAY CLUTCH BEARING REPLACE REWIND SHAFT ASSEMBLY

NOT WORKING

BROKEN BELT REPLACE BELT

LABELS ARE NOT HELD ON LABEL AIR BLOW CHECK FOR BLOWN FUSE

GRID OR LABEL PAD VACUUM FAN NOT WORKING

OBSTRUCTION IN FAN

REPLACE FANS

TAMP INSPECT FOR CLOGGED OR

NOT ENOUGH VACUUM ON PAD DEFECTIVE VENTURI

VENTURI EXHAUST IS BLOCKED

NEEDS MORE AIR PRESSURE

BOTH AIR BLOW & TAMP REFER TO PEEL EDGE ALIGNMENT

PEEL EDGE OUT OF ADJUSTMENT IN THE LABELER SET UP SECTION