Service manual

_____________________

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

LABEL DOES NOT ADVANCE NIP ROLLER NOT ENGAGED INSPECT AND CORRECT

AND DISPLAY IS WORKING AGAINST DRIVE ROLLER

DRIVE BELT IS BROKEN REPLACE BELT

LOST KEY IN DRIVE PULLEY FOLLOW PROCEDURE FOR SLIP

CLUTCH ADJUSTMENT. WHEN YOU

GET TO STEP #6 AND HAVE REMOVED

THE PULLEY GOING TO THE REWIND,

GO AHEAD AND REMOVE THE DRIVE

PULLEY. REPLACE KEY AND PUT

BACK TOGETHER

LABEL DOES ADVANCE BUT DOES NOT LABEL SENSOR NEEDS SET UP REFER TO LABEL SENSOR SETUP

STOP IN THE SAME PLACE EVERY IN THE GENERAL SETUP

TIME OR DOES NOT STOP IN THE PROCEDURES SECTION

RIGHT PLACE

LABEL SENSOR NOT LOOKING MOVE LABEL SENSOR OVER THE

AT A LABEL LABEL PATH

LABEL SENSOR OR FIBER CABLE REPLACE LABEL SENSOR

IS DAMAGED

NIP ROLLER NOT ENGAGED INSPECT AND CORRECT

AGAINST DRIVE ROLLER

LABEL LENGTH SET WRONG REFER TO LABEL LENGTH

SETUP IN THE GENERAL SETUP

PROCEDURES SECTION

LABEL STOP SET WRONG REFER TO LABEL STOP

SETUP IN THE GENERAL SETUP

PROCEDURES SECTION