Service manual

_____________________
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
WITH THE POWER SWITCH ON, POWER CORD DEFECTIVE OR UNPLUGGED INSPECT AND CORRECT
NO COOLING FAN; NO DISPLAY
AC FUSE BLOWN DETERMINE CAUSE AND REPLACE FUSE
WITH THE POWER SWITCH ON, DISPLAY CABLE NOT PLUGGED IN TO RECONNECT CABLE
COOLING FAN ON; NO DISPLAY THE BACK OF THE APPLICATOR
DISPLAY PORT SETTINGS INCORRECT LOCATE SW1 NEAR THE AIR FILTER
MAKE SURE SWITCHES 1 & 6 ARE UP
LOSS OF 12 VDC CALL A FACTORY REPRESENTATIVE
DEFECTIVE CABLE REPLACE CABLE
DEFECTIVE DISPLAY BOARD REPLACE DISPLAY BOARD
LABEL LINER BREAKING LABELS ARE THREADED INCORRECTLY SEE THREADING DIAGRAM
BAD ROLL OF LABELS REPLACE LABEL ROLL
SIDE NICKS IN LINER; REPLACE LABEL ROLL
HEAVY DIE CUT ON LINER
ROLLER COLLARS ARE STRESSING CHECK TO MAKE SURE GUIDE COLLARS
THE LABEL STOCK LINE UP WITH UNWIND
SHOULD HAVE 1/64" CLEARANCE
BETWEEN LABEL STOCK AND COLLAR
ADHESIVE BUILD-UP ON PEEL EDGE CLEAN PEEL EDGE SURFACE
PEEL BAR TENSION SPRING TOO TIGHT RELEASE SPRING TENSION
78