Service manual

___________________________
GENENRAL MAINTENANCE
SEMI-ANNUAL MAINTENANCE
1. Replace air filter and clean collection bowl.
2. Clean inside and outside of machine using an industrial vacuum cleaner.
NOTE: Do not use compressed air to blow dust off of the electrical section of the applicator.
3. Replace slip clutch disk. Clean both friction surfaces.
4. Check roller clutch on the rewind shaft for correct operation.
5. Examine pulleys for wear.
6. Perform the monthly maintenance section.
DANCER ARM ADJUSTMENT
The dancer arm maintains tension on the label liner and operates the brake on the unwind mandrel when
labels are dispensed. The spring holding the dancer arm should be adjusted so that there is enough braking
force to keep the unwind mandrel from continuing to roll after a label feed yet still release the applicator
when it is cycled.
1. Loosen the screw going to the spring tension disk.
2. Rotate disk to proper spring tension.
3. Re-tighten screw.
!!CAUTION!! PERFORM THE FOLLOWING PROCEDURES WITH
MACHINE OFFLINE SO INJURIES FROM UNWANTED
MOVEMENT OF THE APPLICATOR CAN BE AVOIDED.
74