Service manual

___________________________
GENENRAL MAINTENANCE
!!CAUTION!! DISCONNECT THE AIR AND POWER FROM THE MACHINE
BEFORE DOING THE FOLLOWING PROCEDURES.
FAILURE TO FOLLOW THIS PRECAUTION COULD
RESULT IN INJURIES FROM MOVING PARTS OR
ELECTRICAL SHOCK.
MAINTENANCE
NOTE: Since all three types of applicator are covered in this section, some items
discussed will not pertain to your application.
DAILY MAINTENANCE
1. Examine the peel edge, vacuum grid, label pad and rollers for excessive adhesive build-up. If
necessary, clean these surfaces with alcohol or similar solvent.
2. Examine air filter for water or oil collection. Drain if necessary.
3. Examine for loose screws, rollers, etc.
WEEKLY MAINTENANCE
1. Clean rollers, vacuum grid, label pad, and peel edge of adhesive build-up and dust.
2. Examine air lines and connections to make sure there are no leaks.
3. Examine for loose screws, rollers, etc.
4. Examine teflon tape on peel edges. Replace if needed.
MONTHLY MAINTENANCE
1. Examine dancer arm tension and unwind brake O-ring.
2. Examine drive and rewind belts for wear and to make sure they are properly adjusted.
3. Examine rollers for free rotation and play.
4. Examine rewind slip clutch disk for wear.
5. Replace air inlet filter.
6. Examine teflon tape on peel edges. Replace if needed.
73