Service manual

__________________

LABEL OPTIONS SETUP

MISSING LABEL

The applicator has the ability to track missing labels between the peel edge and the label sensor. When a

missing label is detected on the label liner, the applicator will feed a new label to the peel edge at slew

speed.

1. Press the “APPLICATOR OPTIONS” key and select “8) MISS LBL” to enter the missing label

submenu.

2. Select “1) MISSING LABEL: ON” to enable the option. Pressing “1” repeatedly will toggle the

missing label function on and off.

3. Select “2) NUMBER OF LABELS TO PEEL EDGE”. Enter the number of labels between the

peel edge and the label sensor including any labels partially hanging over the peel edge and any

under the label sensor. A valid entry between 1 and 10 will take you back to the missing label

submenu.

4. Press “ENTER” to return to the main menu.

NOTE: 1) When label length is changed, the missing label option is turned off. This insures the

operator will change the number of labels to the peel edge if necessary.

2) If the applicator goes offline, either manually or because of a critical fault, with missing

labels between the peel edge and the label sensor, a warning will come up on the screen.

This message will inform the operator that the applicator will not track the missing labels

when it is brought back online.

3) The second label feed occurs as soon as the blank section reaches the peel edge.

4) Multiple label and leading edge apply options are disabled when using missing label.