Service manual

_____________________________
PRODUCT SETUP PROCEDURE
PRODUCT SENSOR
The factory product sensor is a reflective type. Other types can be used but the following setup procedure
is for a reflective sensor.
1. Make sure the sensor is plugged into the applicator.
2. Turn the power on and leave the applicator offline.
3. Set the sensor to DO (dark operation) by gently turning the output select screw completely
counter-clockwise.
4. Make sure the sensor is aligned with the reflector. When the red LED on the back of the sensor is
flashing at its fastest rate, the two are in the best alignment.
5. Place a product between the sensor and the reflector. The LED should go out.
a). On translucent products, the sensor may fail to detect a product if the sensor gain is set too
high. In these cases, reduce the sensor gain by turning the gain pot counter-clockwise to avoid
“burning thru” the product.
6. Go to the “PRODUCT SETUP” portion on the display.
38