Service manual

___________________________________
LABELER TYPE SETUP PROCEDURE
AIR BLOW PEEL EDGE ALIGNMENT
1. Turn power on to the applicator and make sure it’s offline.
2. Advance the web using the drive roller and notice how the label feeds onto the grid. A normal
paper label should deflect 5-10 degrees to the bottom surface of the label grid. A stiffer label
should feed straight onto the grid.
3. To adjust the peel edge, loosen the two 1/4 S.H.C.S. screws on the peel edge faceplate and move
the assembly to a position close to the grid. Allow enough room for the label and liner to pass
between the peel edge and the grid.
4. Repeat step #2 to check label angle. Re-adjust if needed.
Note: The top of the peel edge should be slightly higher than the bottom surface of the label grid. If
a label on the grid will slide back onto the peel edge, the peel edge is too low.
AIR BLOW GRID SETUP
1. With the power on and the applicator online, jog a label onto the grid and tape it in place.
2. Turn the power off and remove the blow box cover. Arrange the air jet tubes in a symmetrical
pattern with most of the tubes in the center of the label. Insert any unused tubes in the storage
block. WARNING: Make sure the air jet tubes are not in the axial fan.
3. The blow box is equipped with two fans and a switch. With the switch in LOW position, only one
fan will run. With the switch in the HIGH position, both fans will run. Select the appropriate
switch position to insure that enough vacuum is generated to hold the label in place.
31