Service manual

___________________________________

LABELER TYPE SETUP PROCEDURE

AIR BLOW APPLICATOR SETUP

The air blow applicator is a versatile labeler in the sense that many different label sizes can be used without

buying a new pad or manifold. Products can also be labeled at a stand still without contact. The blow box

consists of two axial fans mounted in the top of the assembly that produce the vacuum needed to hold the

label. Inside the blow box are eighteen flexible tubes that provide the air blast to apply the label. These

tubes may be arranged in a variety of ways to apply many shapes and sizes of labels.

1. On the display, under applicator type select “BLOW BOX” applicator. Also, indicate whether it

is in a right-hand or left-hand configuration using the “RT/LT HAND” selection.

2. Place the applicator as close to the product as you can without hitting it.

3. Go through “general setup” procedure (i.e. label sensor, setup, web speed, etc.)

AIR BLOW LABEL STOP

1. With the applicator online, jog a couple of labels.

2. Label stop position should be 1/32” from the peel edge tip.

3. If needed, change the label stop value. (Refer to Label Stop setup in the general job setup)