Service manual

___________________________________
LABELER TYPE SETUP PROCEDURE
CONFIGURING LEADING EDGE APPLY WITH AUTO SETUP
1. Make sure the applicator is powered and offline.
2. Press “LABEL SETUP” and select “5) LEADING EDGE APPLY”
3. Select “1) LEADING EDGE OPTION IS: ON” from the leading edge submenu.
4. Select “3) PRODUCT CLEARANCE TIME / DISTANCE” and enter the time or distance after
the label is dispensed to when the product clears the peel edge. The distance in an encoder system
should be approximately the length of the product that the label is applied to.
5. Press “ENTER” to return to the label setup menu.
6. Select “AUTO SETUP” and follow the on screen prompts (see: AUTO SETUP in GENERAL
SETUP PROCEDURES).
7. Select “WEB SPEED” and enter the product conveyor speed. The “Slew Speed” menu will
automatically come up after web speed.
8. Enter a “SLEW SPEED” value and press “ENTER” to return to the home menu. Slew speed is
the web speed used to move the label to the flagged position in preparation for the next product.
CONFIGURING LEADING EDGE APPLY MANUALLY
1. Make sure the applicator is powered and offline.
2. Using the hand wheel, position the label in the flagged out position.
3. Press “LABEL STOP” and enter the distance measured for dimension D shown above. Note: If
the label sensor is set for trailing edge detection, add the label gap distance to dimension D.
4. Press “LABEL SETUP” and select “3) LABEL LENGTH”. Enter the length measured for
dimension B shown above.
5. Press “5) LEADING EDGE APPLY” to gain access to the Leading Edge submenu.
6. Select “1) LEADING EDGE OPTION IS: ON” from the leading edge submenu.
7. Select “2) SHORT FEED DISTANCE” and enter the distance measured for dimension E above.
8. Select “3) PRODUCT CLEARANCE TIME / DISTANCE” and enter the time or distance after
the label is dispensed to when the product clears the peel edge. The distance in an encoder system
should be approximately the length of the product that the label is applied to.
9. Select “WEB SPEED” and enter the product conveyor speed. The “Slew Speed” menu will
automatically come up after web speed.
10. Enter a “SLEW SPEED” value and press “ENTER” to return to the home menu. Slew speed is
the web speed used to move the label to the flagged position in preparation for the next product.
29