Service manual

___________________________________

LABELER TYPE SETUP PROCEDURE

ESTIMATING RISE AREA AND FLAT AREA

This process will give you a starting point for profile variables. Some experimentation is

necessary for best results. The example shown is for a convex or oval product.

1. Apply a label by hand to the product. Measure the rise area by looking at the beginning of the

label to where it starts to flatten out. Also measure the length of the flat area. Use the diagram

below as an example.

2. Use these numbers when inputting values to the display.

3. When using this type of product, web ratio is set less than “1”. This will slow web speed during

the flat area.