Service manual

___________________________________

LABELER TYPE SETUP PROCEDURE

ENTERING LABEL PROFILING VALUES

1. Press “LABEL SETUP” then select “LABEL PROFILING”.

2. The label profiling menu shows the following three items:

Profile Rise Area

Profile Flat Area

Web Ratio

3. Press “1) PROFILE RISE AREA”. This is the distance the label travels before changing to the

mid-product labeling speed. Enter a value between 0.5 and 20. A valid entry will send you back

to the label profiling menu.

4. Press “2) PROFILE FLAT AREA”. This is the distance the label travels while at the mid-

product labeling speed. Enter a value between .001 and 20.

A valid entry will send you back to

the label profiling menu.

5. Press “3) WEB RATIO”. The web ratio is a multiplier applied to the web speed value to either

slow or speed-up the applicator during the profile flat area. This number will vary depending on

product shape and is usually determined by trial and error. Enter a value between .5 and 1.5.

valid entry will send you back to the label profiling menu.

NOTE: Label profiling is disabled when using the multi –label option.

PROFILING SUMMARY

Condition Product Shape

WEB RATIO < 1.0 Convex

WEB RATIO = 1.0 Flat Surface

WEB RATIO > 1.0 Concave

Web

Ratio

Setting

Speed during

0” to rise

distance

Speed during

rise to flat distance

Speed during flat

to label length

distance

< 1.0 web speed (web speed) (web

ratio)

web speed

= 1.0 web speed web speed web speed

> 1.0 web speed (web speed) (web

ratio)

web speed