Service manual

_____________

REAR PANEL

CONNECTORS

VALVE: When using a Tamp, Blow Box, or a Merge applicator with an imprinter, a

valve bank is mounted to the side of the machine. This plug is used to

power the valves.

ENCODER: The encoder is connected to this plug. The encoder is enabled through the

product setup menu.

ALARM: This connector is for an alarm light. Alarm output conditions include:

No Labels Found

Web Break

Tight Loop at Printer

Offline Critical

Low Label

PRODUCT: This is where the product detect sensor is connected.

LOW

LABEL: When the low label option is used, the sensor is connected here.

WEB/TMP: This is a dual-purpose connector. Either a web break sensor or a tamp

return switch can be connected here (but not both). Enable either option

via the applicator options menu.

DISPLAY: This port is for connecting the display to the applicator.

I/O: This port is for loose loop, alarm signals to a PLC, and imprinter control.

Only one option is available at a time; all are enabled via the applicator

options menu.

LINK: The link port is used to interconnect two labeling heads in “ZERO

DOWNTIME” applications. See CROSSOVER in the SETUP section for

more information.