Service manual

______________________________
CHANGEOVER INSTRUCTIONS
REWIND REMOVAL
1) Remove the belt connecting the rewind clutch to the motor.
2) Remove the rewind mandrel from its drive shaft.
3) Remove the six #10 screws that hold the rewind mounting plate to the housing.
REWIND INSTALLATION
1) Attach the rewind mounting plate to the housing using the six #10 screws.
2) Install the rewind mandrel on the mandrel drive shaft.
3) Install the belt connecting the rewind clutch to the motor.
REWIND CHANGEOVER
1) Remove the bearing block that is mounted to the rewind transition plate.
2) Remove the pulley from the shaft making sure to note its position relative to the end of the shaft.
3) Remove the snap ring from the pulley side of the assembly and push the rewind shaft out through the
mandrel side. Note: The shaft diameter on the mandrel side is larger than it is on the pulley side.
Do not attempt to force the shaft out through the pulley side!
4) Re-install the shaft in the opposite side of the bearing block and replace the snap ring. Note: The shaft
can only rotate in one direction due to a directional bearing in the bearing block.
5) Install the pulley on the shaft in the same position as it was previously.
6) Re-mount bearing block to the opposite side of the transition plate.
WIRING CHANGEOVER
1) Remove the tie wraps holding the AC power wiring and the label sensor fiber optic cable to the
adhesive pads near the wiring entry points.
2) Remove the faston terminal connections at the fuse holder and the AC power entry module.
3) Cut the tie-wraps securing the blow box fan connector to the adhesive mounting pad and move the
connector to the opposite side of the machine. Secure the connector in place with the open end towards
the side frame.
4) Move wiring to the opposite side of the applicator and neatly tie wrap in place.
5) Swap the AC power entry module and the fuse holder with the fiber optic plate and the fuse holder plug.
6) Re-connect the terminals for the fuse holder and the AC power entry module (see drawing on the next
page ).
Note: All wiring comes from the factory long enough to be wired either left or right hand.
104