Service manual

______________________________

CHANGEOVER INSTRUCTIONS

CHANGING TO OPPOSITE HAND DISPENSE

When performing an applicator changeover, the nose assembly, unwind assembly, rewind, and wiring are

first changed to the opposite hand dispense. Then each component assembly is remounted on the opposite

side of the applicator. The symmetry of the applicator main module and the individual parts facilitate the

changeover process but it can be confusing if care is not exercised. The explanation and diagrams to follow

will hopefully guide you through this process.

APPLICATOR CHANGEOVER

1) Remove the nose assembly (See: NOSE ASSEMBLY REMOVAL).

2) Change the applicator nose assembly to the opposite hand dispense (See: NOSE ASSEMBLY

CHANGEOVER).

3) Remove the rewind assembly from the applicator (See: REWIND REMOVAL).

4) Change the rewind assembly to the opposite hand dispense (See: REWIND CHANGEOVER).

5) Change the wiring to the opposite side of the applicator (See: WIRING CHANGEOVER).

6) Change the unwind assembly to the opposite hand dispense.

7) If the applicator is a Tamp or Air Blow, move the valve assembly to the opposite side of the machine.

8) Install the rewind assembly on the opposite side of the machine (See: REWIND INSTALLATION).

9) Install the nose assembly on the opposite side of the machine (See: NOSE ASSEMBLY

INSTALLATION).