C.T.M.
5-Series Instruction Booklet TABLE OF CONTENTS INTRODUCTION --------------------------------------------------------1 IMPORTANT PRECAUTIONS ----------------------------------------2 ELECTROMAGNETIC INTERFERENCE AND WARNINGS ----3 IDENTIFICATION OF PARTS ----------------------------------------5 CHARGING THE BATTERIES ----------------------------------------9 DISASSEMBLING YOUR SCOOTER -----------------------------10 ASSEMBLING YOUR SCOOTER ----------------------------------11 CARE AND MAINTENANCE -
5-Series Instruction Booklet INTRODUCTION Thank you and congratulation on purchasing your new C.T.M. Mobility Scooter. It is designed to provide you with transportation ability indoors and outdoors. We pride ourselves on providing safe and comfortable products. Our goal is to ensure your complete satisfaction. We sincerely hope you enjoy your C.T.M. Mobility Scooter.
5-Series Instruction Booklet IMPORTANT PRECAUTIONS •Only one person at a time could ride a C.T.M. Mobility Scooter. •Maximum load is 136 kgs / 300 pounds. •Turn key off before getting on or off. •Always drive carefully and be aware of others using the same area. •Always use pedestrian crossings wherever possible. Take extreme care when crossing roads. •Do not drive on slope exceeding 10 degree, and take extreme care when turning on slope. •Do not use full power when turning to sharp corner.
-Series Instruction Booklet ELECTROMAGNETIC INTERFERENCE AND WARNINGS CAUTION: It is very important that you read this information regarding the possible effects of Electromagnetic Interference on your motorized scooter. Powered wheelchairs and motorized scooters may be susceptible to electromagnetic interference (EMI), which is interfering electromagnetic energy (EM) emitted from sources such a radio stations, TV stations, amateur radio (HAM) transmitters, two-way radios, and cellular phones.
5-Series Instruction Booklet Motorized Scooter Electromagnetic Interference： Because EM energy rapidly becomes more intense as one moves closer to the transmitting antenna (source), the EM fields from hand-held radio wave sources (transceivers) are of special concern. It is possible to unintentionally bring high levels of EM energy very close to the motorized scooter control system while using these devices. This can affect motorized scooter movement and braking.
5-Series Instruction Booklet IDENTIFICATION OF PARTS Before attempting to drive this scooter on your own, it is important that you familiarize yourself with the controls, and how to operate Swivel Seat With Head Rest Thumb Lever Tiller Angle Adjustment Adjustable Armrest Seat Rotation Lever Basket Seat Sliding Slide Lever Reflector Head Light 11" Front and Rear Wheels Figure 1 - HS-558 / 559 Front View Power/Self-Diagnostic Warning Light Horn Speed Dial Knob Armrest Width Adjustment Thumbscrews
5-Series Instruction Booklet FUNCTION OF PARTS： MAIN SWITCH (A) 1.By turning the key clockwise to ON to turn on the power 2.By turning the key anticlockwise to OFF to turn off the power. 3.By turning the key to to turn on the head light. Speed Dial Knob (B) The Rabbit means fast and Turtle is slow. By turning this you control total speed transferred to thumb controls. Do not set the speed at maximum when operating the scooter.
5-Series Instruction Booklet Thumb Lever Pushing right thumb lever (E) moves scooter forward. Pushing left thumb lever (F) moves the scooter backward. (This can be reversed if required by local dealer.) Releasing both, engages automatic brake. These are also your accelerator. The further you depress them, the faster you go. (Subject to the position of the Rabbit/Turtle control).
5-Series Instruction Booklet Armrest width Adjustment Thumbscrews 1.Loosen the two thumbscrews (K) to adjust arm width tighten again to lock in at desired position. 2.Adjust the attached screw (J)'s height, to control armrest's angle. (J) (K) Figure 10 Anti-tip wheels Helps keep scooter from tipping over. Free-Wheeling Lever (L) When lever is in N (Neutral) position, scooter can be moved manually without power. When lever is in D (Drive) position, scooter can be driven. Normal position is D.
5-Series Instruction Booklet CHARGING THE BATTERIES Batteries must be charged before using the scooter for the first time and should be recharged after each day use. You will need the scooter and the battery charger. Each country may supply different charger. The charging procedure may be different from below. (N) If you require more details, please contact your authorized dealer. (M) Be sure the scooter key is in the OFF position Figure 12 1.
5-Series Instruction Booklet DISASSEMBLING YOUR SCOOTER Disassembling Basket By lifting the basket (O) upwards. Disassembling Seat By lifting lever (H) and seat (a) upward. Rear Compartment Cover Open the Compartment Cover (P) according to arrow's direction. (O) Figure 13 (P) (a) (H) Figure 14 Figure 15 Disassembling Batteries Disconnect front&reat section wire harness (Q) , then tear off battery straps (R) and battery terminals (S) to remove the batteries (b). (Figure.
5-Series Instruction Booklet ASSEMBLING YOUR SCOOTER To assemble scooter, you can repeat disassembly directions in reverse. Abbreviated directions are given below. Refer to Figures on pages 10 to locate parts. 1.Use the tiller adjustment to move tiller up and out of the way. 2.Place front basket. 3.Place battery pack in battery compartment. 4.Place seat on seat post and tighten seat locker knob.
5-Series Instruction Booklet CARE AND MAINTENANCE Cleaning Your Scooter： If your scooter is dirty, use a damp or lightly soapy cloth to wipe it down. Do not use running water to wash or rinse scooter in order to protect electrical parts. Polish with an automotive liquid polish. Maintaining Your Scooter： All maintenance and repair of scooter should be done by an authorized dealer.
5-Series Instruction Booklet OPERATING YOUR SCOOTER You could make the following adjustments to increase your comfort when driving. •adjust seat position. •adjust armrest width to comfortable position. •adjust tiller's angle. 1.Before operating your scooter, check the following: •free-wheeling lever in D •speed dial knob is at turtle picture. 2.Sit on scooter and turn on key, Battery Gauge meter should be indicate at F. The Self-Diagnostic Warning Light should not be blinking. 3.
5-Series Instruction Booklet Keep in mind these rules： •Release thumb levers and allow scooter to stop completely before changing from forward to reverse, or reverse to forward. •When turning to corner, swing front wheels widely, so back wheels will turn more tightly. •Use scooter only where it is safe for waiting. •Drive in low speeds when reversing, riding downhill, over ramp or curb, or on uneven surface, downhill, ramps, curbs, or uneven surfaces.
5-Series Instruction Booklet TROUBLESHOOTING Here are some suggestions about solving problems you may have with your scooter. There is a Self-Diagnostic Warning Light on the Control Panel. To check the Self-Diagnostic Warning Light, turn on the key and count the number of blinks on the Warning Light. Flash Description 1 Battery Low 2 Low Battery Fault Meaning The batteries are running low. •Recharge the batteries. The batteries have run out of charge. •Recharge the batteries.
5-Series 9 Instruction Booklet Other error The controller may have an internal fault. •Check all connections and wiring. Other Problems Low tire pressure: pump up tires to 30-50 lbs. During charging, light on charger does not change to green: Contact your authorized dealer. Scooter will not move when key is turned on: 1.Check Power Reserve Indicator on control panel, it should be lighting in green, yellow, and red zones. 2.Check Self-Diagnostic Warning Light, it should be steady.
5-Series Instruction Booklet TECHNICAL SPECIFICATIONS SPECIFICATIONS HS-558 HS-559 Overall Length 1200 mm / 47.2" 1200 mm / 47.2" Overall Width 620 mm / 24.4" 628 mm / 24.7" Overall Height 1190 mm / 47" 1190 mm / 47" Wheels: Front 290 mm / 11" 290 mm / 11" Wheels: Rear 290 mm / 11" 290 mm / 11" Weight w/ Batteries 87 kg / 191 lbs 96.4 kg / 212.4 lbs Max. Speed 8 kmph / 5 mph 12 kmph / 7.5 mph Weight Capacity 136 kg / 300 lbs 136 kg / 300 lbs 60 mm / 2.4" 60 mm / 2.
