Operating instructions

This allows the operator to select which settings are restored when the R1 is switched on.

Highlight the desired choice using the MENU/SCROLL control and then press the ENTER

button.

DEFAULT (setting)

This will tell the R1 to load the factory default settings every time it is switched on.

LAST

(setting)

If MANUAL mode is selected (see below) this will tell the R1 to switch on with exactly the

same settings as when it was last used. This enables you to turn the R1 off when digging for

deep targets and then switch it back on and resume your searching without having to

readjust the detector.

MANUAL OFF

This turns the manual mode off so when you turn on the R1 you are presented with a short -

cut to the easy to use manufacturer defined programs of:

COIN INLAND

for general purpose searching on

most sites i.e. those not affected by very high

mineralisation or salt deposits.

ALL METAL

for very deep searching of all metals

(no discrimination).

COIN BEACH

for general purpose searching on

the beach or highly mineralised sites.

MANUAL ON

This turns the opening selection screen off so that when you turn on the R1 you are

immediately in the searching mode. Experienced users of the R1 may prefer this setting.

RECALL

DISCRIM GR’ND TYPE COIN INLAND

SENSITIVITY OPTIONS ALL METAL

AUDIO RECALL COIN BEACH

PROGRAMS STORE USER 1

SET UP BACK USER 2

Recalls all settings from the program selected from the list (see also MANUAL OFF above).

STORE

DISCRIM GR’ND TYPE USER 1