Kid’s Adirondack Chair C.R. Plastic Products 341 Lorne Ave. East Stratford Ontario N5A 6S4 Toll Free: 800-490-1283 Fax: 519-271-8544 Web Site crpproducts.
Parts List: A. Seat Qty: 1 D. Stringer Qty: 1 B. Right Arm Qty: 1 C. Left Arm Qty: 1 E. Back Qty: 1 HARDWARE LIST: 1. Screws Qty: 16 Note: Read these instructions carefully before assembling. Tools required: # 2 Phillips or #2 Robertson bit and power drill. Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the plastic surfaces. Wait to dispose of the packing material until assembly is complete and all parts and hardware are accounted for.
Step 1: Set the Seat and Back legs (A) on a flat surface as shown. Using factory installed screw as a pivot, spin the back legs out and around until the bottom edges are flush or parallel to the long angled cut. Tighten these two screws. Put one more screw in each leg using the counter sunk holes provided. Item Drawing Qty 1 2 Seat Assy. (A) Screws 1 2 Step 2: Place Back (E) onto the back of the Seat assembly, resting it on top of the Back Legs (A).
Step 3: Place the assembled Seat and Back on a flat surface as shown in Fig. 3A. Take Left Arm (C) and attach with a screw as shown in Fig. 3A bottom view X using peck mark for alignment Make sure you use the top hole as shown. Repeat using Right Arm (B). Step 4 Stand partially assembled chair on front of seat and arms as shown in Fig. 3B. Fasten back end of Left Arm to back leg centering as shown in view Y. Repeat for Right Arm. Step 5 Flip chair back as shown in Fig.
