B32 St. Tropez Love Seat C.R. Plastic Products Inc. 1 – 533 Romeo Street South Stratford Ontario N5A 4V3 Toll Free: 800-490-1283 Fax: 519-271-8544 www.crpproducts.
A. Back Qty: 1 B. Seat Qty: 1 C. Left Arm Qty: 1 D. Right Arm Qty: 1 PARTS LIST: A - Back B - Seat C - Left Arm D - Right Arm HARDWARE LIST: 22 – 1½” Screws 4 – 2” Screws NOTE: Read these instructions carefully before assembling. Tools required: # 2 Phillips or #2 Robertson bit and power drill. Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the plastic surfaces. Two people might be required for assembly. Caution!! Do not over tighten screws.
Step 1: Set the Left Arm (C) flat on the floor Fig. 1. Line up Seat (B) keeping bottom edge of seat flush with bottom edge of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail V) and attach with 6 - 1½” screws. Required Seat (B) Left Arm (C) Figure 1 1½” Screws Qty 1 1 6 V Keep front edge of seat back 1/8” from the front of leg. Keep bottom edge of seat flush with center rail of arm. Step 2: Using Right Arm (D) to balance Back (A) Fig. 2. Line up Back (A), (detail W ).
Step 5: Flip assembled part of love seat over on to Right Arm (D), keeping bottom edge of seat flush with bottom edge of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail Y) and attach with 5 - 1½” screws. Step 6: Line up back and insert 2 - 2” screws to attach the back to the curved arm rest, (detail Z) keeping screw holes centered on arm. Step 7: Insert 4 - 1½” screws.
