User Manual

Shutter Top
STEP 1
Attach the top to the shutter using the
clips provided. Align shutter and top on
a flat surface. Join pieces together by
pushing each clip on as far as it will go.
Use two clips per top. See Figure 1.
Proceed to Step 1A for Raised Panel,
Solid and Transom top installation with
transom clips.
STEP 1A
A transom clip will also need to be
installed in addition to the two (2)
clips. Start by pushing one end of
the transom clip onto the shutter,
clamping the shutter to the top. Work
the transom clip down until the entire
clip is fastened to the shutter. Be sure
the transom clip is pushed on as far
as it will go. See Figure 1.
STEP 2
Fasten shutter to wall using instructions
supplied with shutter. To prevent shutter
from dimpling, do not over tighten.
REQUIRED FOR INSTALLATION:
Electric drill, 1/4" drill bit (Shutter-Loks
®
), 11/64" drill bit (screws), screwdriver, screws or Shutter-Loks.
NOTE: Note that Louver and Elliptical tops, do not require transom clips.
Shutter
Top
Clip
(front of assembly)
(back of assembly)
1/4" hole
Transom Clip
Clip
Support rib will
need to be removed
Clip
Figure 1
1/4" hole
Transom Clip
Clip
Support rib will
need to be removed
Clip
Figure 2
Drill one (1) 1/4" hole as shown in
Figure 2. For Transom tops, drill two
(2) holes as shown in Figure 3.
STEP 3
Figure 3
1/4" hole