Instruction Booklet

SLIDERIDE
SlideRide Models: SR, CSR, ASR
C-MORE Systems
Voice - 703-361-2663
Fax - 703-361-5881
e-mail - sales@cmore.com
web - www.cmore.com
CMS-IB-SR-041608
Congratulations! You are now the owner of the most advanced reflex sighting system available. You have displayed
excellent judgement in your purchase, and you will be rewarded with unparalleled performance. Use it with pride, but
please familiarize yourself with the system first.
PLEASE read instructions before operating or installing this sighting system.
1.Beam Splitter Lens
2.Elevation Adjustment Screw
3.Battery Cover
4.Diode Cover
5.Diode Module
6.Intensity Switch
7.Windage Guide Pin
8.Elevation Locking Screw
9.Windage Adjustment Screw
10.Windage Locking Screw
INSTALLATION
The SlideRide sight can be mounted to most flat surfaces; custom mounts, shotgun ribs, etc.
1) First, find the mounting holes in the sight. The front hole is just behind the lens. The rear hole is between the
diode module and the battery. (The battery and diode covers will need to be removed to access the rear hole).
INTENSITY SWITCHES
C-MORE sighting systems are available with two switch styles, standard and click adjustable. The standard is a
dial rheostat switch with a continuous adjustment through the wide intensity range. The click adjustable switch
has 12 positions. The first position is off and the second and third are for night vision (low / high) and are not vis-
ible. Positions 4 - 12 are the visible intensity settings giving you a wide range of adjustment for any lighting con-
dition.
INTENSITY ADJUSTMENT
The intensity of the dot needs to be adjusted to the lighting condition in the operating area. The dot should
appear bright but not glaring. For example, outside in bright sunlight you will most likely use the brightest set-
ting, while at dawn or dusk, or indoors you will need to use one of the lower settings. The first two positions on
the click switch are extremely dim and can only be seen through a Night Vision device.
PACKAGE CONTENTS
Models - SR, CSR (Polymer Bodies)
Qty 1 - Instruction Manual
Qty 1 - SlideRide Red Dot Sight
Qty 1 - Hardware Pack = (1) Hex Wrench 1/16, (1) Hex Wrench 5/64, (2) Extra Cover Screws,
(2) Mounting Screws 10-32 x 1/2
Models - ASR (Aluminum Bodies)
Qty 1 - Instruction Manual
Qty 1 - SlideRide Red Dot Sight
Qty 1 - Hardware Pack = (1) Hex Wrench 1/16, (2) Extra Cover Screws, (2) Mounting Screws 10-32 x 1/2
1
2
3
4
5
6
7
8
9
10
Instruction Manual
© C-MORE Systems 1993-2008
2) Using the 10-32 cap socket screws provided, secure the sight to your base. DO NOT OVERTIGHTEN! Firmly
snug is sufficient. Applying Red Loc-Tite to the mounting screws will prevent the sight from loosening under
recoil.
2.080”
Rear Mounting Hole Front Mounting Hole
(Top View)
Note:
Tap drill size for 10-32 = #21 Drill
STOP!! Make sure your firearm is unloaded and the magazine
and ammunition has been removed before proceeding!

Summary of content (2 pages)