Data Sheet

C-MAX Beacon BC08
Datasheet
SPEC No.
C-MAX Beacon
BC08 DataSheet
Revision
1.3
State
2019-12-17
Printed
2020-03-26
Version
English
Page
7 of 8
C-MAX
5.2 FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
5.3 Important Note
The device is limited to OEM installation ONLY
1. We hereby acknowledge our responsibility to provide guidance to the host manufacturer in the event
that they require assistance for ensuring compliance with the Part 15 Subpart B requirements.
2. The host manufacturer is responsible for additional testing to verify compliance as a composite
system. When testing the host device for compliance with the Part 15 Subpart B requirements, the host
manufacturer is required to show compliance with the Part 15 Subpart B while the transmitter device(s)
are installed and operating. The devices should be transmitting and the evaluation should confirm that
the device’s intentional emissions are compliant (i.e. fundamental and out of band emissions) with the
Radio essential requirements. The host manufacturer must verify that there are no additional
unintentional emissions other than what is permitted in the Part 15 Subpart B or emissions are
complaint with the Radio aspects.
This device is intended for OEM integrator. The OEM integrator is still responsible for
1. ensuring that the end-user has no manual instructions to remove or install device
2. the FCC compliance requirement of the end product, which integrates this device.
3. Appropriate measurements(e.g. 15 B compliance) and if applicable additional equipment
authorizations (e.g. Verification, Doc) of the host device to be addressed by the integrator/manufacturer.
4. The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
5. 20cm minimum distance has to be able to be maintained between the antenna and the users for the
host this device is integrated into. Under such configuration, the FCC radiation exposure limits set forth
for an population/uncontrolled environment can be satisfied.
6. Any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment.
7. That device is limited to installation in mobile or fixed applications, according to Part 2.1091(b)
8. The maximum antenna gain required for authorized antennas per Part15. 204 (including ant. spec.)
The user manual of the end product should include
In the users manual of the end product, the end user has to be informed to keep at least 20cm
separation with the antenna while this end product is installed and operated. The end user has to be
informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be
satisfied. The end user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than the palm of the hand, then additional FCC part 15.19 statement is
required to be available in the users manual: This device complies with Part 15 of FCC rules. Operation
is subject to the following two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may cause undesired
operation.
6. RED Statement