Data Sheet

C-MAX Beacon BC08
Datasheet
SPEC No.
C-MAX Beacon
BC08 DataSheet
Revision
1.3
State
2019-12-17
Printed
2020-03-26
Version
English
Page
6 of 8
C-MAX
(1 sec broadcast interval)
broadcast interval = 1 sec,
Output power = +0.4 dBm, 25
°C , 50% humidity
Beacon Interval
1
sec
Default
Average Current
(Before Activation)
5
uA
Scanning for activation
Average Current
(After Activation)
14
uA
1 seconds iBeacon broadcast
interval + 20 seconds Battery
Level Advertisement Interval
Range
30
m
At default broadcast output
power and interval, 25 °C , 50%
humidity
Operating Temperature
-10
+60
°C
3V operating voltage
4. Ordering Information
Part Number
Description
Colours Available
Image
CMP-9304BC08-A
Beacon Main Unit
Black
5. FCC Warning Statement
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
5.1 Caution
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that may cause undesired
operation.