Operating instructions

Planning

Please ensure that you are familiar with the installation

requirements as well as the relevant British Standards and

Statutory Regulations (see page 3) before commencing work.

Location

The CALYDRA can be installed on any suitable internal wall.

Provision must be made to allow the correct routing of the flue

and siting of the terminal to allow the safe and efficient

removal of the flue products. The appliance may be installed

in any room, although reference must be made to the IEE

regulations if it contains a bath or shower. A compartment or

cupboard may be used provided that it has been purpose-built

or modified for the purpose. It is not necessary to provide

permanent ventilation for cooling purposes. Detailed

recommendations are given in BS 5440 pt 2. If it is proposed

that it is installed in a timber framed building then reference

must be made to British Gas Document DM2, or advice

sought from CORGI.

INSTALLING THE CALYDRA

Installation

The installation kit included with the flue components

comprise following items :

- Hanging bracket

- A paper template (showing the dimensions of the boiler with

5 mm side clearances and fitting instructions and on the

reverse, the fixing positions for the spacer bracket)

- Connection tails

- Screws and wall plugs

- Connection washers

- Pre-piping jig

- Installation and Operation manual

Positioning the boiler on the wall.

The paper template can be used to ensure the correct

positioning of kitchen cabinets etc.

The paper template is fixed to the wall and used to locate the

position of the hanging bracket, the centre for the flue hole

and, if required, the fixings for the pre-piping jig.

If there is a requirement to pass the piping behind the

boiler, it will be necessary to fit a spacing bracket. This is

available as an optional accessory. The standard paper

template shows the positions for the spacing bracket

fixing screws.

chaffoteaux~

a-u