Manualshelf

Installation & Assembly

ManualsBrandsC&M by Chapman & Myers by Generation Lighting ManualsChandeliersGardner 6-Light Drum Chandelier
12
1
Installation Instructions for
1.0
C 1166C
C 1166C
Temporarily install the mounting plate to the junction box and mark the anchor hole locations through the mounting plate holes, then
remove the mounting plate.
Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box and screw the anchor screws into the anchors.
Place the spacer onto the fixture and secure in place by screwing the stem onto the fixture. Repeat for each side. Then Place the
wire frame over the stems and secure it in place by screwing the fixture loops onto the stems.
Install the candle tubes by slipping them over the sockets.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Install the quick link to bottom end of the chain, then secure the quick link onto the fixture loop.
Install the quick link onto the remaining end of the chain, then secure the quick link onto the canopy loop.
Weave the cord through the chain, canopy, and out of the junction box. Trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all wires into the junction box/canopy, place the canopy onto the mounting plate, and secure it in place using cap nuts.
1
2
1A
3
4
Gardner Linear Chandelier
Chandelier
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
5
6
7
8
9
10
11
12
13
14
CHAIN
CANOPY LOOP
ANCHOR SCREW
MOUNTING PLATE
CANOPY
QUICK LINK
QUICK LINK
JUNCTION BOX
5
7
12
CAP NUT
ANCHOR
FIXTURE LOOP
5
13
3
2
LAMP
CANDLE TUBE
SOCKET
6
5
STEM
FIXTURE
4
4
6
5
WIRE FRAME
7
8 8
99

Summary of content (2 pages)