Installation & Assembly

1
Temporarily install the mounting plate to the junction box.
Mark the anchor locations through the holes on the mounting plate. Remove the mounting plate.
Drill appropriate sized holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box and screw the anchor screws into the anchors.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the junction box/fixture base, mount the fixture onto the mounting plate,
and secure it in place using the fixture screws.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage Information.
Install the large panels to the lower frame by sliding the loops through the opening at the end of the frame. Repeat for middle
and upper frames.
Install the small panels to the fixture base using the screws.
1
2
3
4
5
6
1A
Install the Fixture
JUNCTION BOX
MOUNTING
PLATE
A:6PC B:18PC
7
8
SMALL PANEL
LARGE PANEL
SCREW
FIXTURE SCREW
ANCHOR ANCHOR
SCREW
LOWER FRAME
MIDDLE FRAME
UPPER FRAME
B
A
9
10
3 4
8
9
11
10
11