Installation manual

SYSTEM 236 Installation Manual

Keypad Operation Command Summary

The majority of the keypad commands apply equally to the LED and Alpha II keypads. Some keypad commands, however, apply

to the LCD keypad only.

The following Keypad Commands apply to both the LED and Alpha II keypads:

Function Comments Keystroke Sequence

Arm/Disarm Delays active [Combination] [#]

Bypass Zone (n) [n] is zone # 1 - 6; Combo may be required [Combination] [*] [2] [n] [#]

Chime On/Off [*] [5] [#]

Change Combo Must be done from Master Combination [Master Combo] [*] [0] [#] [User No.] [#]

(User #1) [New Combo] [#] [New Combo] [#]

Clear Alarm Memory [*] [1] [#]

Entry/Exit Pre-Alarm Toggle Pre-Alarm tones on and off [*] [5] [2] [#]

Error Tones Toggle Error Tones on and off [*] [5] [4] [#]

Exit Programming [*] [#]

Home Arm All interior zones are shunted simultaneously; [Combination] [*] [4] [#]

Exterior zones armed; Combo may be required

Instant Arm Converts all delayed zones to instant; Combo [Combination] [*] [7] [#]

may be required

Instant Home Arm Arms exterior zones, shunts interior zones, [Combination] [*] [4] [7] [#] (or)

Entry delays converted to Instant; Combo [Combination] [*] [7] [4] [#]

may be required

Keypad Activated RPS If enabled, CL 09(4); Combo may be required [Combination] [*] [0] [2] [#]

Keypad Tone Disable Toggle Entry/Exit Pre-Alarm and Confirmation/ [*] [5] [1] [#]

Error tones on and off

Panic Alarm Keypad activated [9] (Hold for 3 seconds)

Reset Aux Power If resettable devices are connected to [*] [6] [2] [#]

Terminals labelled AUX (+) and C

Reset Panel Panel must be disarmed [Master Combination] [*] [6] [8] [#]

Test - Battery Use after correcting Low Battery problem [*] [6] [4] [#]

Test - Bells Combo may be required [Combination] [*] [6] [3] [#]

Test - Central Station Combo may be required [Combination] [*] [6] [1] [#]

Test - Local Walk Test Combo may be required [Combination] [*] [6] [0] [#]

NOTE: For additional information about Combination Command requirements, see page 26 and CL 08 (5).

Alpha Keypad Programming Start Programming the Keypad [Installer Combination] [*] [0] [1] [#]

Alpha Keypad Test Keypad must be disconnected from panel [*] [6] [7] [#]

Kill/Revive Panel Panel must be disarmed [Installer Combination] [*] [6] [9] [#]

Panel Programming Start Programming the Panel [Installer Combination] [*] [0] [#]