Operating instructions

LOCAL SYSTEM TEST

This option allows on-site testing of each zone in your system.

To initiate the SYSTEM TEST:

Enter your PIN (if required),

push the key, enter the digit "6",

the digit "0", then push the # key.

The display will read WALK TEST. Walk through the

areas protected by motion sensors; open and close

protected doors and windows. Each time a zone is faulted, the display

will show the faulted zone's identification, and the keypad will chime.

REQUIRED

6 0

WARNING:Your alarm system will not report alarms during the LOCAL SYSTEM TEST.

To exit the system test, push any key. The display will momentarily read

SYSTEM RESET.