User`s manual

7. Cut the cable tie on the Module
Connection Wire. Then Plug the
connector into the socket on WLAN
module.
【 Note 】
Please cut the cable tie carefully. Do not
damage the Module Connection Wire.
8. Align the WLAN module to the Ethernet
port and plug into it.
9. Secure the module onto the back plate.
10. Thread the Module Connection Wire
through the other connection wires on the
mainboard as the direction showed in
figure. Then arrange the Antenna
Connection Wire as the arrow showed.
【 Note 】
Please organize all cables and wires well
before putting middle compartment and top
cover back to ensure that the printer can be
assembled correctly.
11. Remove the Antenna port cover from
back plate of the printer.
12. Thread Antenna Connection Wire through
the hole on the Antenna Bracket. Then
put the Antenna Connection Wire and
Antenna Bracket on the Antenna port as
figure showed.
EZ-1000Plus User’s Manual
26