User`s manual

5. Plug in the stripper
connector onto the
switchboard socket.
(refer to the right figure)
【 Note 】
There are 2 sockets on the
converting boards (one is for
stripper installation, and
another one is for cutter),
before plug the connector into
socket, please check the pin
first.
6. Place the left side of the
stripper first, and then fit
the right side.
7. Hold the stripper module
and tighten the screws.
8. Feed the label through
the Label Guides.
【 Note 】 The label / paper
used for stripper is suggested
to be at least 20mm in height.
【 Suggestion 】 When printing
with stripper module, it is
suggested to set the stop
position (^E) to 9.
9. Peel off the first label,
and feed the liner
through the roller and
the Tear-off Bar.
EZ-1000Plus User’s Manual
19