User`s manual

3. Accessory
3-1. Stripper Module Installation
1 Stripper Module
2 Screw (TAP 3*8) x 2pcs
【 Note1 】 Please power off
the printer before installing the
stripper module.
【 Note2 】 Label liner
thickness is recommended to
be 0.06mm ± 10% with basic
weight 65g/
㎡ ± 6%.
【 Note3 】 The max width for
stripper is 110mm
2
1
1. Open the top cover by
pressing the Cover
Open Buttons on both
sides.
2. Loosen and then lift the
upper print mechanism
by pressing the locking
tenons.
3. Unlock the front cover
piece by pushing locks
inward.
4. Lift/take off the front
cover piece according to
the direction shown in
the figure.
EZ-1000Plus User’s Manual
18