Specifications

C-giant rel 3.07. Sales by Jemba, Sweden. Tel +46 (0)586 55640
Page 24 C-giant
5.10. Set up units in C-giant
You may select different
units for distance and speed
in a special set up mode. Also
the communication for a
printer (option) may be set.
From factory the unit is set up to the standard setting for your market. If you want to
change units it is important to have your desired units set up before the calibration
takes place. After the calibration has been carried out, the set up may be changed
without re calibrating the unit.
You may exit any time from the set up mode without changing anything by pressing
'RESET'.
You have now set up your C-giant to show your desired units. Even if the instrument
is disconnected from the power supply it keeps it set up in its memory.
The following selection keys and choices are available (the corresponding flash text is
shown within brackets):
DISTANCE (selection key is 'TRIP1'):
meters (MEtEr)
miles (MiLES)
RESETOPTION
CAL
SPLIT
89
HALT
7
BREAK
ADD
0
PILOT
6
FUEL
5
TIME
4
TRIP1 TRIP2
12
SPEED
3
SET
by Coralba Sweden
.
.
.
-giant
Procedure C-giant shows
Select any trip meter or 'SPEED' Selected register
Press 'CAL' Current calibrating constant
Press 'RESET' (Enter set up mode) .SEtUP.
Indicator flashes
Press any of the selection keys as Flash text shows current setting
listed below
Press the same key once more to change Flash text shows new setting and
.SEt.UP. starts to flash, indicating
that something has been changed
Repeat selection key until desired
set up is ready
Press SET (store with SET-key) If something is changed you will be
brought back to the 'BREAK' status.
Otherwise to calibrating constant