Specifications

C-giant rel 3.07. Sales by Jemba, Sweden. Tel [phone]
C-giant Page 23
Repeat until the tank is filled up and five values are stored.
If you want to abort the sequence once you have started it − just press RESET before
the sequence ends and the old values are restored.
Now the fuel gauge is calibrated. Even if C-giant is disconnected from the power
supply it keeps it calibrating constant in its memory.
Action C-giant shows
Press FUEL uncalibrated amount of fuel
Press CAL .C.Pnt-1 flashes
Press SET 0 flashes
Input current amount of fuel in the tank. 0
As the tank is almost empty you feed a "0"
Press SET .C.Pnt-2 flashes
Fill about ten litres.
Press SET xx flashes
Feed the current amount of fuel in 10
the tank (10)
Press SET .C.Pnt-3 flashes
Fill about another fifteen litres.
Press SET xx flashes
Feed the current amount of fuel in 25
the tank (25)
Press SET .C.Pnt-4 flashes
NOTE!! If you get the error indication Ad.-Err it means that the voltage from the fuel
sender was unchanged for two calibration points. Is the ignition switched on?
If you get the error indication Fu.-Err it means that you didn't increase the amount of
fuel between two calibration points.