Specifications

C-giant rel 3.07. Sales by Jemba, Sweden. Tel [phone]
Page 20 C-giant
5.6. Monitoring average speed (PILOT)
The Pilot is a useful tool to monitor your actual position in respect of the scheduled
time. This is important when the road sections are long or some service is required on
the car. By storing the required average speed into the SPEED register the time gained
or time delayed is read in the PILOT register. The sequence is:
RESETOPTION
CAL
SPLIT
89
HALT
7
BREAK
ADD
0
PILOT
6
FUEL
5
TIME
4
TRIP1 TRIP2
12
SPEED
3
SET
by Coralba Sweden
.
.
.
-giant
Store required average speed:
Unless you set the start value to zero with 'RESET' you set the PILOT register to its
value with the normal SET and ADD procedures as described on pages 18 and 18:
SET procedure:
This input may be done any time before start by setting time to start as gained time.
Then the pilot will count down to zero at starting time.
Set the counting direction of the PILOT register to the desired counting direction with
(+), (-) or HALT. NOTE!! These three keys only have an impact on the measuring of
distance in the PILOT, not on time measurement!. An implication of this is that if
you make a mistake and drive one part on a road section on a wrong road and you
have to go back to the correct section again you just set the PILOT to (-) when you go
Action C-giant shows
Press 'SPEED' (select SPEED register) Speed of vehicle
Press 'SET' (start input of value) Current PILOT-speed flashes
Set average speed with numeric keys New PILOT-speed flashes
Press 'SET' (store with SET-key) Current speed of vehicle
Action C-giant shows
Press PILOT (select PILOT register) Time gained or delayed
Press SET (start input of value) Current time gained or delayed
flashes
Set start value with numeric keys 0 to 9 Start value flashes
Press SET (store with SET-key) Current time gained or delayed