Specifications

C-giant rel 3.07. Sales by Jemba, Sweden. Tel [phone]
Page 16 C-giant
5.1.4. Automatic measurements on special stages (SS)
By repeated pressing on 'TRIP 2' you will get access to a number of registers that will
give you automatic measurements on special stages. This is a great relief for the co-
driver at the start and finish of special stages. By resetting TRIP 2 the automatic
measurement of the length, time, top speed and average speed is initiated. The
measurements will start automatically when the car is driven the first metre . When
TRIP 2 shows its first metre a watch is started and from elapsed time and travelled
distance the average speed is calculated continuously. At the finish of the stage you
just press SPLIT and can then read the different values by pressing TRIP 2 repeatedly.
Except for maximum speed it is not possible to control this function in any other way
than by changing TRIP 2. The maximum speed may be reset to zero separately. See
also below for monitoring time of arrival.
5.1.5. Estimated time of arrival
By storing the length of your current road section (into the register for .EtA.diS) you
can get your estimated time of arrival at either current speed or average speed. This
function is useful when accessing the required speed on a particular road section and
also working out the servicing time available. Select the function by repeatedly
pressing TRIP 2.
You can also input the required time of arrival to give out the required average speed
and your margin in time. This is done by inputting the required time into the register
for .EtA.-A. and reading the required speed in the register for .A.SPEEd. Your margin
in time in respect to your required time of arrival (positive or negative) at current
speed is read in the register for .EtA.Cur. This function is indicated with a flashing
indicator in the TRIP 2 key when you select .EtA.-A, .EtA.Cur or .A.SPEEd. This
mode of operation is aborted by selecting .EtA.-A. and pressing the RESET key.
Action Flash text C-giant shows Shown format
TRIP 2 .triP..2 Distance travelled xxx.xxx
TRIP 2 .SS.Hour Time since Trip2 started to count xx.xx.xx
TRIP 2 .A.SPEEd Average speed, calculated for Trip2 xxx.x
and .SS.Hour, unless flashing indicator
(see below)
TRIP 2 .toP.SPd Maximum speed xxx