Product Manual

6
4. Snap the wire protection grommet into the 9/16”
hole of the side of the tongue near the skid holes
as shown.
5. Pass the wires through the grommet and out as
shown. Roll up as much wire outside the
grommet as the white wire is long as shown.
6. We will let gravity do the work of threading the wires. Pass the wires down through a large socket
and back up again as shown. No need for a knot. With the tongue tipped up, feed the heavy
socket into the end of the tongue. It will slide thru the tongue pulling the wires with it.