Product Manual

27
8. With both bunks in place,
tighten the swivel
brackets at the desired
angle, width and height
to best fit your craft.
9. Set your craft on the
trailer and make any fit
improvements as
needed.
10. Lift your tongue. You
should have a tongue
weight of about 10% of
the weight of the
combined load. Slide
the craft forward or back
on the trailer until the
tongue weight feels good, then move the winch stand assembly to meet the bow of the craft at this
position and tighten everything down.
11. Go around the trailer and double check that everything is now fully tight and secure.
12. Before you can register your trailer with your State’s Department of Motor Vehicles (DMV) you
must apply the supplied VIN sticker to the towing tongue near the coupler, and the supplied tire
certification / load capacity placard to the frame in a conspicuous location near a tire. Your
completed trailer will then be
ready to register and title.
Contact your local DMV
office for specific
procedures in your State.