Product Manual

19
7. Route the wires thru the cross member as shown. Carefully tuck the wires into the frame rails so
you are sure of their permanent place along the frame. About 2” behind the side marker lamp
use your knife tip to carefully divide about 1/2” of the 2 conductors taking great care to only divide
the wires without cutting either conductor. Then grasp and separate by hand about 3” of wire as
shown above
8. Press brown wire into the Quick Tap
connector as shown. Then insert the
wire from the side lamp fully into the
2
nd
opening in the Quick Tap. Use
pliers to squeeze the Tap blade down
and thru the insulation. The blade
cuts thru the insulation and connects
the wires inside. Flip the cover to
lock the connector. Repeat on the
other side.